Loadbank Operator Instructions

• Remove all transport covers completely before proceeding 
• All loose materials that could block air intake to be removed away from unit while unit is testing 
• Unit operates at very high temperature under load so all precautions should be taken to avoid exhaust air coming into contact with combustible material 
• Unit should not be operated in areas where air flow is restricted
• Connect power cables to bus bars 
• If supply is not 415V 50Hz an external supply is required to power the fans 
• Set selector sw to internal/external supply as required. Sw located just below bus bars terminations 
• Press fan start 
• Before entering load make sure fans are blowing air across elements 
• Follow instructions in the blue window 
• Enter kW load and press enter 
• For new load press reset, press the number of kW required and press enter 
• Any mistakes when entering load will bring up instructions in blue window 
• Follow instructions and resume test 
• When load test is complete allow five to ten minutes to cool down fans
• Any problems contact Auspower EDM
• Unit will drop load off if temperature rises above a set level
• Allow unit to cool and resume test  

Control All Units via the hand controlled 'combined'

• Connect all units together  
• Make sure interconnection leads are connected male to female sockets. male to male will damage the unit 
• Follow instructions in hand controller view window, combined load  

Control all units via the hand controller 'individually'

•  To enter load on individual units press view  
•  To enter individual loads on each unit press update and enter kW for unit selected 
•  Press view to go back to combined